... about 1mm as shown in Fig.1
and extract the contact by pulling wire.
Recommended board dimension is 1.1*0.5mm
(2) How to raise up a lance
In case the extracted contact is...
The criteria is;(1) Signal contact
The fillet is formed and gets wet sufficiently.
(2) Power contact and reinforcement metal The through hole is filled with solder firmly.
...liance with European safety standards applicable to final products and devices.
Therefore, CE marking is not applied to electrical and mechanical parts such as connectors.
...k.
Silver oxidizes in the air and becomes oxidized silver.
And silver also sulfurizes by sulfur that is contained in corrugated carton.
As the results, the color becomes black.
...
... P-shell unit of HR25-9P-12P
and the spanner hook portion of the cord pipe is pinched with a vice.
Then it becomes a substitute of fixture.
Because the parts used as jigs m...
Those are HR212-10P-8P(41), HR212-10LP-8P(41) and so on.
There are several connectors differed by color and type of cable exit.
HR212-10P-8P(41) is black straight cover
HR212...
...clearance between the contact and the wire even if wire is inserted.
The solder may not be bonded well, because there is no space for the solder to flow.
As DF12 series(Not Recommended for New Design) and DF12N series are vertically & laterally symmetric on the mating side,
they can mate with the mate even if it is rotated 180 ...
The Company site may obtain some information using cookies.
In cases where the application will demand a high level of reliability, such as automotive, please contact a company representative for further information.